grahamlee8819 Posted March 15, 2015 Share Posted March 15, 2015 Hi this is my first experience with polyurethane and im not sure if this is normal or will it mold and fit better with some heat applied? mainly concerned about the corner its almost like the lip isn't long enough Thanks Quote Link to comment Share on other sites More sharing options...
Grundy Posted March 15, 2015 Share Posted March 15, 2015 Just pull it round, will be fine. Heat can help. Quote Link to comment Share on other sites More sharing options...
grahamlee8819 Posted March 15, 2015 Author Share Posted March 15, 2015 will i get enough heat from a hair dryer? Quote Link to comment Share on other sites More sharing options...
steve916 Posted March 15, 2015 Share Posted March 15, 2015 Tiger seal all along it, then as above, pull the ends into place and secure with a couple of self tappers. Quote Link to comment Share on other sites More sharing options...
grahamlee8819 Posted March 16, 2015 Author Share Posted March 16, 2015 Ok guys there doesn't seem to be much "pull" will give it another go with heat at a letter date thanks for the replys oh and I was going to use 3m tape rather than tiger seal as the paperwork suggests just because it's more reversible Quote Link to comment Share on other sites More sharing options...
Tarmac@TarmacSportz Posted March 16, 2015 Share Posted March 16, 2015 Heat will make it more flexible and stretch around the back. Quote Link to comment Share on other sites More sharing options...
grahamlee8819 Posted March 16, 2015 Author Share Posted March 16, 2015 Cheers have you still got a 5 week wait on ts diffuser btw?? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.