Andymac183 Posted September 30, 2016 Share Posted September 30, 2016 I'm replacing my front bumper with an Aerokit Spec R-2 and purchased a Torquen undertray to give the whole thing some rigidity...except the undertray front edge falls short of the bumper by several inches! So now I'm guessing the undertray ONLY fits OEM bumpers and the R-2 must stick out further than that...the bodyshop has offered to make some brackets/plates but I wondered if I had missed something? Anyone else with a new bumper, how'd you get the undertray sorted? Quote Link to comment Share on other sites More sharing options...
Jetpilot Posted September 30, 2016 Share Posted September 30, 2016 Its not unusual for aftermarket stuff to not marry up to oem sadly, only real option is to take up the offer from the bodyshop. 1 Quote Link to comment Share on other sites More sharing options...
KyleR Posted September 30, 2016 Share Posted September 30, 2016 I cable tied mine to the Nismo V2. 1 Quote Link to comment Share on other sites More sharing options...
evilscorp Posted October 1, 2016 Share Posted October 1, 2016 My old ings bumper was held with cableties too, this time I have chosen to lay some more fiberglass over the bottom section so it now marryies up and will improve areo. 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.