MrLee Posted May 30, 2016 Share Posted May 30, 2016 I've read up a bit on the removal of the existing knob, but I was wondering if anyone could confirm if the existing thread would mean an aftermarket knob was sit really high as a result? I don't want to be doing silly things like cutting it shorter, but on the same front, I don't want to have it looking silly. Looking at something similar to this: Quote Link to comment Share on other sites More sharing options...
Ekona Posted May 30, 2016 Share Posted May 30, 2016 Depends on the knob, but most sit lower. Quote Link to comment Share on other sites More sharing options...
Tinyflier Posted May 30, 2016 Share Posted May 30, 2016 I think I took a few mm off the shaft when fitting my MOMO knob (which is fixed using 3 grub screws it doesn't screw on) and ended up with this. Quote Link to comment Share on other sites More sharing options...
MrLee Posted May 30, 2016 Author Share Posted May 30, 2016 Oh that's not so bad at all... I might give it a go then. Thanks Quote Link to comment Share on other sites More sharing options...
KyleR Posted May 30, 2016 Share Posted May 30, 2016 It'll be fine, the Zeds shall is pretty short Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.