Jump to content

Tein Coilovers


Andy

Recommended Posts

*Note to Mods - I wasn't sure where to put this so please feel free to move if you think another section is more appropriate. Ta *

 

 

Has anyone got experience of fitting Tein Coilovers with EDFC? How easy are they to do and would I be stupid in undertaking the fitting myself? I'd like to think i'm pretty mechanically savvy. but don't want to strip the car down and then panic as I haven't attempted something like this before.

 

Do I need specialist tools or expert assistance in setting them up??

 

If it's going to be too much of a job then I think I will get them done by a professional as it's quite a major problem if I balls it up!

Link to comment
Share on other sites

*Note to Mods - I wasn't sure where to put this so please feel free to move if you think another section is more appropriate. Ta *

 

 

Has anyone got experience of fitting Tein Coilovers with EDFC? How easy are they to do and would I be stupid in undertaking the fitting myself? I'd like to think i'm pretty mechanically savvy. but don't want to strip the car down and then panic as I haven't attempted something like this before.

 

Do I need specialist tools or expert assistance in setting them up??

 

If it's going to be too much of a job then I think I will get them done by a professional as it's quite a major problem if I balls it up!

 

 

A lot depends on how adept you are with mechanicals it can be a bit daunting and to get the best out of them you do need to have them setup properly.

We have fitted quite afew of these kits now total job takes about 3 hours.

Link to comment
Share on other sites

Yeh I wouldnt attempt it at all, my mechanical savvy extends as far as putting carbon stick ons to my car thats about it. Although I am interested in getting some tein springs but worried about clearing my wheels as dont want them to run on the arches. Have 10.5 at the rears by 19 with 285 x 30 tyres. With it clear this if I lower with the teins or will the arched have to be shaved? :headhurt:

Link to comment
Share on other sites

Yeh I wouldnt attempt it at all, my mechanical savvy extends as far as putting carbon stick ons to my car thats about it. Although I am interested in getting some tein springs but worried about clearing my wheels as dont want them to run on the arches. Have 10.5 at the rears by 19 with 285 x 30 tyres. With it clear this if I lower with the teins or will the arched have to be shaved? :headhurt:

 

Clearance will depend on the offset of the wheel.

Link to comment
Share on other sites

Yeh I wouldnt attempt it at all, my mechanical savvy extends as far as putting carbon stick ons to my car thats about it. Although I am interested in getting some tein springs but worried about clearing my wheels as dont want them to run on the arches. Have 10.5 at the rears by 19 with 285 x 30 tyres. With it clear this if I lower with the teins or will the arched have to be shaved? :headhurt:

 

Clearance will depend on the offset of the wheel.

 

What does offset mean again :blush:

Link to comment
Share on other sites

Yeh I wouldnt attempt it at all, my mechanical savvy extends as far as putting carbon stick ons to my car thats about it. Although I am interested in getting some tein springs but worried about clearing my wheels as dont want them to run on the arches. Have 10.5 at the rears by 19 with 285 x 30 tyres. With it clear this if I lower with the teins or will the arched have to be shaved? :headhurt:

 

Clearance will depend on the offset of the wheel.

 

What does offset mean again :blush:

 

:lol: basically the offset will determine how your wheels "stick out" or dont, which in turn will affect how much they are likely to rub if you slam the car

Link to comment
Share on other sites

Yeh I wouldnt attempt it at all, my mechanical savvy extends as far as putting carbon stick ons to my car thats about it. Although I am interested in getting some tein springs but worried about clearing my wheels as dont want them to run on the arches. Have 10.5 at the rears by 19 with 285 x 30 tyres. With it clear this if I lower with the teins or will the arched have to be shaved? :headhurt:

 

Clearance will depend on the offset of the wheel.

 

What does offset mean again :blush:

 

:lol: basically the offset will determine how your wheels "stick out" or dont, which in turn will affect how much they are likely to rub if you slam the car

 

My wheels stic out slightly had my cambers changed, would it help if I posted the readings on my camber set up to identify if I can put lowering springs on the car?

Link to comment
Share on other sites

Found offsets:

 

The front offset is +17 and the rear offset is +18.

 

They are 9.5x19 front and 10.5x19 rear :thumbs:

 

your wheels sit the way they do because your car is not lowered :)

 

My setup is far more aggressive than yours, but its lowered, and sits at the edge (does not stick out

 

yes you will need the rear arches rolled

Link to comment
Share on other sites

Three hours for an install is about right -- did it right in my driveway. I also did brakes and rotors (StopTech) at the same time. The install is not difficult at all. The most challenging part is routing the wires for the EDFC.

 

I dropped her about an inch all around. No problem with fender/wheel well clearances, even with much wider tires (245 front and 285 rear) and a fairly significant offset on the rear.

 

I drove for about a week to settle everything and then remeasured and fine tuned my height settings.

 

brk-sus1.jpg

 

brk-sus3.jpg

 

t350-103.jpg

 

t350-102.jpg

Link to comment
Share on other sites

Tere if you were in England and single,and I was single, id ask to marry you, there is nothing more appealing than a lady who can modify their cars better than the rest of em. I am in awe :notworthy:

 

Ps if you come to England beware of stuey :lol:

LOL... I loved England when I was there on a regular and frequent basis -- mostly East Anglia. I was younger and much more foolish then. :D
Link to comment
Share on other sites

Tere that looks B) And how lucky are you to have some sunshine to make the car look even better.
Right, as I look out the window right now and see nothing but gloom... But then again this afternoon the sun will probably pop out from wherever it's hiding. ;)
Link to comment
Share on other sites

Tere that looks B) And how lucky are you to have some sunshine to make the car look even better.
Right, as I look out the window right now and see nothing but gloom... But then again this afternoon the sun will probably pop out from wherever it's hiding. ;)

 

Gloom?? Tell us about it. been totally dark here all day, very very gloomy. :lol: You would not love England right now. :headhurt:

Link to comment
Share on other sites

Tere that looks B) And how lucky are you to have some sunshine to make the car look even better.
Right, as I look out the window right now and see nothing but gloom... But then again this afternoon the sun will probably pop out from wherever it's hiding. ;)

 

Raining hard here with winds around 60-70 mph. What's more it's only 4.00 pm and it's nearly dark already. I hate the winter :rant:

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...