Ian

And if thats not enough - UK cars didnt start till late 03 & are all on 53 plates Single din stereo No steering wheel controls Intake has the extra hose on it Also that boot shut looks awful

Its a JDM. It even says so in the advert

Use mine quite a bit with no issues aswell

Is that the sensor at the forward end of the air intake pipe? Yup

I get about 200 miles to £80 450 miles this month & I'm just over 1/4 through my 3rd tank

To be completely honest mate, with the way the market is going I think you be able to get a half decent uk one for that soon I think it will be a while before a decent UK car drops that low TBH. The market is all over the place at the moment, its near impossible to put a price on one imo I put dibs on your car Ian for when you come to sell it When your ready

Just a set of rails. I'm not sure if Recaro make rails for the Z though. I'm pretty sure the few on here that have fitted recaros have used bride rails but there are a lot of options from bride

In the Z - I'd probably call police & get them done for criminal damage In my company car - I'd open my door into theirs pretty hard (have done this before when someone has done it to me & walked off claiming they never )

To be completely honest mate, with the way the market is going I think you be able to get a half decent uk one for that soon I think it will be a while before a decent UK car drops that low TBH. The market is all over the place at the moment, its near impossible to put a price on one imo

Z is easy to work on It does like to draw blood though

Edit: 12K posts

WTF

Easiest way is to do it by first pm gets it

Assuming that I get up early enough I will be

If the rest of that road wasnt filled with potholes then I would have done a longer run at it My turning is fine I'll show you how to make a nicer turn.... are you taking her out on track? would love to hear and see it a full flyby! I'd love to get it out on track, I just need to find one with no noise limits. Its gonna be a load of work to get the current setup below 105DB

Slippery slope

Probably all stems back to when nobody would give him a free aerial

How do you know that has spacers fitted? Could just be the right offsets Hellaflush - When the tyre is flush to the wheel arch, requires the right offsets & suspension setup Offset - The offset of a wheel determines how far it sits out or into the arch. The lower an offset the further OUT it will sit, the higher the offset then the further IN it will sit Air - Cars fitted with airbag suspension, allows for a car to be fully slammed. Stance - The way that the wheels & suspension sit against the bodywork. Again the better the setup the better looking stance you have Rolled arches - Pretty straight forward, the lip inside the wheel arch is heated & rolled to run more agressive wheels. Spacers - Spacers will push your wheels out further thus lowering your offset Camber - This is the angle that your wheels sit at - like / \ would be negative camber \ / would be positive camber Think that covers everything I would get pictures to show you each one but I'm lazy, maybe tomorrow

Scangauge is dead easy to use & shows 4 different gauges at once. You won't get oil temp from an OBD reader but intake & water temps you will. I think my scangauge is setup at the moment to read intake temp, battery voltage, throttle postition & water tem (might be something other than water though) I might look into getting something like the R34 MFD, If i can get one cheap enough to play around with & then ditch all my Defis

Depends what your planning on doing with it. Do you want something that just monitors in real time & clears codes or do you want something more in depth? I use a scangauge 2 in my car, cost me about £120 i think