-
Posts
402 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Store
Everything posted by Kryptek49
-
I'm getting a private plate next month, and wanted to get a reduced legnth front number plate - 355 x 111mm. The plan was to remove the current number plate bracket from the front and stick the number plate directly on to the bumper over the now exposed holes. Only problem is the bumper is curved, so will the plate fit properly if I just stick it on or will I need to modify anything? Thanks
-
Perfect thanks I'll get a new amplifier and hope for the best then! Just to confirm, this: https://www.ebay.co.uk/itm/151999594178 is the part you replaced?
-
Is there anyway to verify the amplifier is not working correctly? i.e Multi-meter to test voltage via the pins? My head unit does get signal though, it is just fairly crackly when in other cars there is no issue. Does this sound similar to your problem? Thanks for the help
-
My 57 plate HR has the stock head unit in it, however one of the previous owners had installed an aftermarket HU in it, but this has been reverted back to stock. The radio signal in the car is pretty terrible, I can jump in my other half's car and the radio is crystal clear, but in my car parked 2 metres away its very fuzzy. The car currently has a short antenna on it, however I have swapped this back to the OEM antenna and this makes no difference on the car. I have pulled out all the wiring on the back of the head unit to check nothing was missing. There were a few odd cables that the PO left in place however I have now removed these so everything is back to stock. The antenna wire that goes into the back of the HU is connected securely, and the green/white power antenna wire is securely connected to the brown plug, and then goes into the back of the HU with the main wiring loom. Everything looks right, but I don't know if I'm missing something here? Should the power antenna wire have power when the car is on? If so does anyone know what voltage this should be at so I can check with a multimeter later today? Or does the car just have poor radio reception normally?
-
Sold
-
Just bought an RDX aerial from H-Tune as my radio signal is pretty terrible - turns out the aerial isn't the problem, so I now have 2 stubby aerials. I'm keeping the new one I've bought, and I think the old one is from a Honda Jazz, but it looks identical and the reception is exactly the same as the RDX. £5 including P&P. On a side note - anyone have any idea what could be the cause of the crap signal? I can hop in my other half's car and put on the same channel and it's not crackly at all... Excuse the dirt on the car, I've just got back from a 4hr drive and the roads are covered in crap.
-
£70 now if someone wants this
-
Yeah I'd heard that high gear, low speed, uphill is a good test for a slipping clutch. I took the car uphill in 6th at about 40-50mph and it pulled slowly but strongly, definitely no clutch slip there. Yes off the throttle - clutch down - clutch up while applying revs - revs hang for a second - back to normal. This has only happened twice in my 3 months of driving. Once shifting to 4th, and this time when shifting to 5th
-
I've owned my HR for around 3 months now, and have noticed the following happening twice in a month. I was putting my foot down on a straight and shifting through 2nd, 3rd, 4th with no issues. I put the car into fifth and as I pulled the clutch up the revs didn't drop down immediately. I shifted somewhere between 5-6k I think. Normally as soon as the clutch is up the revs drop right down, but they hovered at around 4k for maybe a second then went back to normal. The accelerator was pushed to the floor the whole time the revs were hanging. Is this my clutch slipping? The car is on 97k miles, but I've got an invoice for a new clutch and DMF that was installed roughly 30K miles ago, so any clutch issues would be quite early on in its life? Anyone got any advice on this? Thanks.
-
PDF still works fine for me, I've uploaded it for you again here Fixing the FuelGauge.pdf
-
[SOLD]**SOLD** 2008 Night Blue 350Z 65K For Sale Clean Mods
Kryptek49 replied to eroll_350z's topic in Zeds For Sale
Good price - I'm sure this will sell quickly. I paid £8,150 for my HR a few months ago and that had 95k miles on it, only difference was mine had the gallery gaskets done, but this has a better service history - I would definitely have bought this a few months ago! Love the colour too -
bump - still available
-
I've recently replaced the side light bulbs in my HR with some Osram W5W LED's, I'd tried using cheaper eBay LED's however these typically started flickering after a week of use. I installed the new bulbs today, and the one on the right is not working anymore. The socket you push the bulbs into was quite loose on the right hand side which I believe is the issue. The plastic socket looks quite weak/brittle though, so I'm not sure if clamping it so its a bit tighter would damage it. Has anyone got any recommendations for what I can do here? I've had to take the wheel and arch liner off about 3 times each side now, so I'm hoping I can finally fix this for good! Thanks for the help
-
I enquired about this last month - looks great and I'll definitely get it done soon: Option 1 - Thicker, Perforated leather on sides, Smooth top/bottom, Orange or other colour of stitching - £140.00 Option 2 - Thicker, Thumb grips Built up + Flat bottom, Perforated leather on sides, Smooth top/bottom, Orange or other colour of stitching - £210.00 Option 3 - Full Modification with Flat bottom and Extra Grooves, Perforated leather on sides, Smooth top/bottom, Orange or other colour of stitching - £215.00 + £9.99 postage & £100 refunded deposit. Optional Alcantara + £15 Here's a photo of each option: https://imgur.com/a/YnsBbvJ
-
never getting 100% throttle showing / pedal heights
Kryptek49 replied to raptor07GT's topic in Performance
Just checked - highest I got was 86% as well. My car's been UpRev remapped, and it still only hits 86% when in the aggressive throttle response map. -
never getting 100% throttle showing / pedal heights
Kryptek49 replied to raptor07GT's topic in Performance
I'll take a look on the Torque app later and see what max throttle I can get to. Have you looked at installing the 380rs pedal? It has a wider bottom so is easier to heel-toe Can't say anything about the HR jerk - I believe the PO of my car said that it was an issue on my HR at one point, however after having it remapped (UpRev) there has been no issue. -
These look really good - I'll have to send them a message. Do you remember what they cost you? Thanks
-
Perfect thanks guys
-
I've purchased some cheap LED's off ebay to replace various lights around the car, however I keep having to replace them as they start flickering after a few weeks. Are there any decent websites that sell T10 LED bulbs that actually work? I've had a search on the forum, but everything I found is 4 years old and the links are now dead. Thanks for the help
-
I'm looking at picking up a private plate in a couple of months. I've had a plate printed at Halfords before and it was starting to peel around the edges after being used once on a trailer. Can anyone recommend a decent website/place to get these done? I've seen some nice "4D" ones, but don't know if these are actually legal or not? Thanks
-
You could swap the plastic trim for the version with the cubby hole instead? Not that cheap a mod though unfortunately, especially if you have to buy the parts new: https://www.torqen.uk/nissan/350z/body-styling/interior/10976-350z-hr-nissan-oem-68260-cf45a-center-console-bezel-radio-gauges-non-navigation-06-08-68260-cf45a.html https://www.torqen.uk/nissan/350z/body-styling/interior/10970-350z-hr-nissan-oem-lid-cluster-cubby-68250-cf45a.html It would be easiest to replace the centre console with the non-navigation trim, then replace the stock radio for an updated model if you want something more modern. I'm sure other people have fitted screens instead of the sat-nav though, so there are definitely other options
-
Damn that sucks - let me know if you want me to take any pictures for you of any particular wires
-
I use a G1W - about £30-£40. Quality is good enough, probably the best price/performance you can get
-
Just checked mine today, and yes it does illuminate. It's pretty faint though, and I would say not worth the effort needed to get it to work
-
FYI - I bought 5L of oil from halfords I didn't need and no receipt - took it back about 3 months after buying and they gave me a refund based on current prices. Might be worth a go if you're local to a halfords. Nice offer though
- 1 reply
-
- 1
-