Jonnymonno

Hello and welcome

I had this issue on my 370 with the Torqen coilovers and it was the diameter of the bolt is a few thou smaller than the diameter of the hole in the bottom of the coilovers,so no matter how tight you tighten it up it stays loose. As a temporary fix I wrapped shim steel around the bolt to test it and the clunk went away This will definitely be your problem if the 350 is the same Good luck

Hello and welcome

Hello and welcome

I have the Motordyne Shockwave and Art decat pipes fitted and the combined system is very loud. It's ok up to 3000rpm then very loud but sounds awesome above. MOT time is a pain too, either swap to standard cats or find a friendly tester. The Art pipes certainly bring the noise down in the cabin. Quality wise it's the Motordyne every time but very very loud Sent from my iPad using Tapatalk

Yes they are the Nismo mk1 (LMGT5) wheels, only ever seen a set for sale on eBay a while ago and there were only three due to the car being written off

Very nice

Hi nub Yes all the creature comforts are gone but they are very comfortable and grip you well and the bonus of a lot of weight saving over the standard seats Fitting wise isn't too difficult, just time consuming and making sure they are safely fitted. The Motordyne is very loud and with the ark decats even more so but it's not a daily driver so not too bad No chance of passing a noise test on any track in this country now I looked at many supercharged badges including ones similar to yours but I think I will be removing them from my car as I,m going back to the debadged look

Hi Teejay Not sure about silverstone yet and no probs for the use of the pit.

No problem, give me a shout anytime.

No problem mate, can't believe how much lighter they are too than the originals I nearly fell over when I felt the weight of my stock seats Told you, it's like losing the weight of a passenger

Very nice, best colour white, but then I'm biased

Hello and welcome to the forum

I fitted mine to my 370 and had to fabricate some brackets but pretty straightforward with a bit of fiddling If you go for it I can make the brackets up for you once you know what you need Look at my build thread as to how I fitted them

Are you sure it isn't just the small front flaps that hang down under the front bumper? as mine is lowered and clears the tray and Stillen front which is very low

How much nicer it looks with the arch trims gone, looks much better, get those rears off

Hello and welcome to the forum

Hello and welcome to the forum

SOLD. MODS PLEASE LOCK

Hello and welcome

About time

Bump

Wait till Zeditis bites and your wallet will never be the same again

Have altered the title thanks

Where are you in the country?