Briggsybriggs1

True true. I got a quote from a company and they wanted £800.. thats £400 per seat. More than I was hoping ;p check this out http://www.350z-uk.com/index.php?/topic/81203-New-Leather-seat-covered They look really nice as well mate Sent from my iPhone using Tapatalk

Thanks for the replays every one think I need a up rev now. It dropped to 22mpg after fitting the filter now after the decats it's 20mpg so think a up rev is needed now then. But am going to refit my OEM air box cos until it's done :-) Sent from my iPhone using Tapatalk

Hi as above iv just fit some decats and a cone filter to run along with my duplex exhaust system and my mpg has dropped to 20 from 26-28 , but the sound is amazballs now , is it normal to lose mpg after fitting breathing mods ? Sent from my iPhone using Tapatalk

Me :-) Sent from my iPhone using Tapatalk

plus 1 Sent from my iPhone using Tapatalk

You should always keep the power wire away from the RCA leads and specked wires as it interferes with the sound some times that's all you really need to no mate and it's easy to install in a zed. Just run the power wire from the battery to the amp throw the big bung in the bulkhead next to the battery and then seal it up to stop water getting in to the car :-) And with the sound proofing just put it every were you can start from were the speakers are sat then work you way from that :-) Sent from my iPhone using Tapatalk

Will get some poor boys black hole glaze for next time. Thanks for your advice every one :-) it the firsts time iv done a full stage detail Sent from my iPhone using Tapatalk

Very nice :-) Sent from my iPhone using Tapatalk

Sent from my iPad using Tapatalk

sounds like you had fun on them the I just did them when doing the hole car so it prob was about 15 min a side , Sent from my iPad using Tapatalk

Nice one be good to have a before picture too though Found some they were taken on iPad so not that good Sent from my iPad using Tapatalk

Just done my head light one was looking old, just got some T cut on it lift it for ten min then buffed it up by hand , repeated this 3or4 times then just but some Wax-polish on it looks really good :-) it's a cheap and easy way cos everyone's got T cut in there shed Here is what it came out like Sent from my iPad using Tapatalk

The title should be enough to put you off leather like !!!!!!lol, Sent from my iPad using Tapatalk

thanks mate will give it a go later on :-) Sent from my iPhone using Tapatalk

Just used And it looks like this now And my question is can I now use these to finish the job ? Or am I wasting my time ? Thanks for any information :-) Sent from my iPhone using Tapatalk

I like it :-) Looks well but if you were to slap some 20inc rims on it would tone it down a bit. Sent from my iPhone using Tapatalk

Welcome along wave Sent from my iPhone using Tapatalk

All payed up :-) Sent from my iPhone using Tapatalk

All payed up :-) Sent from my iPhone using Tapatalk

Looks well now it being dropped mate :-) cAn u still get over speed pumps with that front lip ? Sent from my iPad using Tapatalk

roadsters are ace mate. Sent from my iPhone using Tapatalk

Welcome along wave Sent from my iPhone using Tapatalk

Welcome along wave Sent from my iPhone using Tapatalk

I would go for second had until u can save up for something u really wAnt . I went with a top gear exhaust duplex s/s and de cats . Check this site out price includes fitting on some offers http://www.roarpower.co.uk/exhaust_for_350z.htm I got my system from them and for the price I can't complain Sent from my iPhone using Tapatalk

Looks massive :-) Sent from my iPad using Tapatalk