Keyser

Hello and Welcome

Opps unlucky mate - Feel for ya!

Hello

Hello and Welcome

Sorry I'll try and pick up the pace a bit It's not like adding Neon's you know these things take a while

Good evening another day in the shed and was very happy with the result. The plan for today was to attack this - So I set about it with my trusty sandblaster and after a mere 4 hours I had it to this point - So back underneath for another 4 hour session O what fun LOL, Anyway As the light started to fade I was happy - So cleaned the Zedshed up fixed a few sheared studs and bolts in captive nuts including this one which I decided replacing with a bolt would be the best option so I ground it level, drilled it through and ran an M6 die through. Sorted Treated all the bare bits with some Jenolite and moved onto the really fun bit a spot paint and by the end of the day I had this - That's all folks ............

No takers really ?? Come on Yes............ my rates are very reasonable **edited for spelling mistake - Neo**

Its finished Yayyyyyy No not the car the exterior strip down is complete everything we need to take of the outside is of. I don't actually think there is much more we could take of Last job was to wrap it up ready for Christmas ...... well cleaning and under sealing ..... That's all folks

Looking good mate Keep the updates coming sounds like its gonna be very "gangsta"

You can order a new flexi on line from fleabay or a performance car parts site - then you just need someone to weld it on, they may do it if you got the part? Something like http://www.ebay.co.uk/itm/2-25-x-10-Exh ... 4a9f6d6ccb

Hello again it never stops round here, Well it does I broke my welder last night so sacked it early, Went to the shop today and got a Teflon liner new swan neck, tips and a new shroud £37.50 later and my welder is as good as new. So had a good night tonight even though there were a few problems to overcome. Started of welding a new nut in here as the bolt sheared of during the strip down Then onto these sheared bolts - 3 in this piece When I ground out the old studs I discovered a split in one end and a rusted through top plate at the other - So I set about with my welder and built it back up again It's probably stronger than new now Onto this little beauty 2 problems, firstly it hits the ground on speed bumps and secondly its been used as a jacking point - great place to jack from but it bends the bars!! So I thought I would add a plate to act as a skid pan and use as a stronger jacking point. Cut some heavy weight plates from some metal I acquired on my travels. Clamped them in place and back on the welder Finished modification Then over to the body shop (I know it's just a tarpaulin I hang round the wall but it sounds cool) Primer coat That's all folks ...............

Thanks for the comments I hope I can remember where it all goes as well Yes sandblaster for the clean up does ally a treat and takes the rest back to bare metal.

Congrats mate great news

Hello and Welcome Have a look at - viewtopic.php?f=17&t=23843 If you havent already

Thanks for the links

Hello and Welcome Good luck with the hunt Full service history and check for the bits mentioned above you should be good.

Cleaning again ...... Some bits really need it But it's getting there ..... Hope to give them a coat of primer tomorrow night. That's all folks ...................

Hello and Welcome Good luck with the hunt

Hello and Welcome

About time - nice one mate

Hello and Welcome

Hello and Welcome

1 ton of crushed glass for the sand blaster correct Mind you I liked Karate Chimps version more

Hello and Welcome You may notice a difference ??