Keyser

Can you get bt infinity or virgin - both can offer some very good speeds. Other than that I find they are all fairly equal for every one person who likes one company someone else says they are pants Its all the same lines at the end of the day (bar cable of course)

What is a "gym" ??

Just pass that onto Jay please 15mm all the way Jay

and your Tannabe is as well

Fixed that for you

Have a look under the passenger side (if it's a right hand drive) Your looking for the bit I have circled on the gear box if you have this then it is the external type if not it will be the internal some Zeds are not this colour underneath I did the slave cylinder and changed to a braided line and new fluid on my last 350 sorted me out for prices I'm sure he has them in stock and good to go

Did someone say pic whore??? Invidia G200 true dual

No worries my man Always a pleasure to remove a bit more rust from your Zed Sounds great again

It usually starts slipping

Never done any prep I use 3 different tyre fitters/suppliers depending on which car/van never had a problem with any - never had them attack my wheels with a wire brush either

Probably

Did you get a price?

Ok I will start the bidding at £500 £500 ha - not even a bag of dolly mix thrown in

nice

I see you were over the edge in Bournemouth Next time your passing give us a shout

OUCH

You have bears in you garage? thought that was just Doogy

Like that Keep us posted

shame you only have the diagram version

Set off early to AME and after a not very enjoyable 3 hours on the road (traffic was bad during rush hour) I got there at 10AM. After Dan had sorted some other clients (I kept busy drinking his coffee ) we rolled her into the Dyno room Firstly we put some oil and water/antifreeze in her and spun her over with no plugs check oil pressure - all good (flat battery not withstanding) Then new spark plugs bolted the coil packs in and attempt number 1 at a start up Click the video below and mind you ears!!!!!!!!!!!!!!! Bit of belt slip maybe? So after a little tweaking and sorting within 10 minutes we had this (vid below) .... No smoke So Dyno run in next Tuesday, an oil change then mapping and a couple of little jobs and (hopefully) I'll get her back at long, long last! That's all folks ............................