rodgeevans

I will take steering wheel if you still have it please

Love the Brembos i have a yellow set sitting in my garage for about 2 years and still not got round to fitting them

Don't run power and rca together can cause interference best doing power down passenger side and rca through centre

I did some pics of running cable into the doors etc in my build thread. Removed all seats and the trim panels including boot to do my install

New cables no doubt about it don't use existing ones likely to burn out and could cause a fire

Oh...I just had exactly same panel and pretty sure I had abbey sticker in same spot haha Lol don't like stickers on outside of car personally but still wanted the abbey sticker on it and thought this was the best place. That mishimoto is different to mine but looks a good alternative

No was a brand new slam panel when I bought it. The coolant and power steering tank came from a trader called chilli red doesn't trade anymore I don't think and I believe they were discontinued anyway only way to get any is second hand I believe

Here's mine

This was originally mine I believe, few pics from when it was fitted i never did like the finish but was already on my car when i got it, was imported with it fitted. Dont think there any other genuine ones in the UK or at least there wasn't. Hope they help people

Can i ask where you got it from the crankshaft Sensor and was it the one on the underside of the engine

Black one is mine I was in the Chinese for a mates birthday. Though got a stock bumper on whilst mine is resprayed. I did see you turn up the road I think we're you in a black also, I was meaning to put it on here but been really busy the ginger was already there when I arrived.

Thanks Guys I was worried about going any bigger 255/275 with that offset as thought it may then require arch work.

Hi my friend wants/needs new tyres for his 350z as it came with a stretched look. He has 18x9.5 ed35 with 25mm spacers all round so an offset of +10mm I believe. It currently has 235/40 all round, Now I want to check this is correct and would fit without rubbing, I have suggested 245/40 on the front and 265/40 on the rear can someone confirm this is ok. Many thanks

Looking very nice Scott good progress since I last saw you around town, makes me want to restart work on mine got so many bits that need doing or i want doing. Keep up the good work

Im in Essex too, Although went round to my mums to dig them out last night and my step dad had moved them out the garage at some point in last few weeks and they have been out in all this rain not sure if that will affect them,

where you based i got a set laying around too from when i switched to HFC's

Rattled penny jar and not enough in there unfortunately, balls

Thanks guys unfortunately ran out of daylight without getting it moving but will pray for better luck tomorrow got mot at 4 so hope it goes better tomorrow got the spade chisel ready and a blow torch and angle grinder as last resort

Thanks Alex I been soaking it in wd40 and tried prying it off and it not budged an inch will give it another soaking and try again loosing the will with it.

Currently under the car trying to replace the arm all nuts removed but still cant get the arm off its stuck on this bolt any suggestions please or am i missing something

Heres the posts i made about it at the time http://www.350z-uk.com/topic/72848-mpg-clocks-etc-still-in-jap/ http://www.350z-uk.c...__fromsearch__1

You can change the triple dials to Uk ones to get mpg reading then put in a Uk Heater control brain and the clock works too

Sorry been a while since I been on here moving house etc has meant the zed has been on the back burner for a while, you need to leave the Reader in whilst you want to use but I remove it when not in use.

Also gota set of jdm 17s based in essex.

Wallpaper steamer easiest way to remove and leaves no residue Took me about 30 seconds a front side window with a steamer