Kev T

That is a very tidy bonnet now, good job.

Hello and welcome to another ( rare ) titanium grey Z

Hello and welcome.

Hello and welcome

lovely !

Hello and welcome.

Hello and welcome to another 370 owner.

Hello and welcome.

Hello and welcome.

Hello and welcome.

Hello and welcome.

Hello and welcome.

As above LY65 +++ around 10am today.

Hello and welcome.

Hello and welcome.

Hello and welcome.

Hello and welcome.

Same here, i probably won't get it fitted until the summer.

Hi Mikey, just to let you know my Ducktail spoiler arrived today and very nice quality it is, very pleased. Thanks for arranging. Kev

I think i have seen on the USA forum a mod to fit extra washers under the rear seat bracket to raise up the height.

Hello and welcome.

Hello and welcome.

The rear fog light is an LED fourth brake/reversing/stop light which replaces the existing fog light and is available from traders on this forum.

Here you are step by step : Having read extensively about the steering lock failure, even the supposed revision C/D i decided to take fate in my own hands and remove the fuse that controls it, not wishing to be stranded or being given a hefty bill by Nissan to replace it when my warrenty runs out in a few months time! Many people in the USA have done this mod which takes about 10mins to do without any issue whatsoever and of course is replaceable in the same amount of time should you require to do so .I have lifted the pics from the American site cos my camera battery flat, so everything in pics is on the opposite side on our cars ( passenger side ) under battery cover. I first removed the battery cover held by push clips... . Remove the battery bracket. There are 4 plastic clip holding it. Pop the plastic clip open with a flat headed screw driver and pull it out. Slide the bracket towards the passenger side wing as the bracket is under the stiffening bar. Remove HALF of the plastic weather stripe. The weather stripe goes all the way to the driver side so you don't have to remove the entire thing. There are 4-5 clips that needs to unplug. To remove them, gently twists and pull upwards (these clips are plastic so they will break). You can now fully access the fuse box. Pop open the two clips and slide the box upwards. Open the box and locate the fuse and remove it. The first picture shows where I pulled the fuse and the second one denotes it's location in the box. MAKE SURE THE CAR IS IN 'ACCESSORY' MODE FIRST!!!!

Hello and welcome.